The wiring of domestic led linear strip lens moulds is actually divided into two levels, which are divided into wire wiring and signal wire wiring. The following is shown:
domestic led linear strip lens Wiring criteria for moulds
One: wiring
The domestic led linear strip lens moulds are actually consistent with the ordinary switch, and at the same time a little simpler than the ordinary switch. The actual wiring method is basically distributed by the welder, the actual will not do a detailed indication. There are some differences, mainly. The wiring of traditional switch mainly takes full account of the fact that some lights must be double-controlled switch or even three-controlled, so the wiring is more complex. However, with the current domestic led linear strip lens moulds wiring, the problem of multi-control is not considered at all, as long as the corresponding lighting effect wire is connected to the matching switch cartridge. In other words, thoroughly according to the single control to carry out wiring. So, how to complete the multi - control regulation? This is the second part of the signal line to solve
Two: signal line wiring
Today's domestic led linear strip lens moulds, the key performance of intelligence is the mutual control between switch and switch, switch and switch between the formation of an Internet, according to the transmission of data signals and instructions in the Internet, to achieve the goal of intelligent control system. For example, the multi-control just now transmits instructions to the switch of specific wiring according to the signal line, and instructs the switch to turn on or off the lamp.
In order to make a network of switches, signal wires must be used to connect all switches to each other. Signal cables belong to weak wires. Actual operations, such as grooving and piping, must follow the wiring standards for weak current installation. As for the wiring of the most popular 485 communication protocol domestic led linear strip lens moulds, actually the wiring is relatively simple, just use the signal line to connect each switch box, the interface mode is more flexible.
domestic led linear strip lens moulds has already become a highly accepted commodity in the sales market, but there is still a long way to go before it is popularized. One of the factors holding them back is that many people are not sure whether domestic led linear strip lens moulds are available in their homes or how they should be wired. Hope after reading this article can give you a little inspiration.
domestic led linear strip lens moulds https://www.tangrammould.com/Lamp-Accessories-Mould
Comments (0)