A brief introduction of the downhole tool

A downhole tool is a hydraulic oil recovery system that includes an above-ground unit, a submersible unit, and a reciprocating downhole pump unit. When the upstroke and downstroke occur, the system aids in the continuous pumping of oil. This method aids in the doubling of oil production while not really increasing energy consumption during the process.

Prerequisites for DownholeTool

In order to activate the reciprocating pump unit of the down hole, a water-based fluid is preferable over a hydraulic fluid. Coil tubing is used to move the water-based fluid through the apparatus or system. This mechanism, which creates exceptional benefit in many oil wells, also depends on coil outside production tubing.

 

Oil Well Downhole Tool

The mechanism used by downhole equipment for oil well pulling and running allows a work string to be released in the form of a tool assembly and then reattached if required. Pressure is increased after detachment across an existing pressure that pushes the ball through the seat and into a cage in order to make the circulations, which is to pump the downhole fluid up the annulus of the oil well as well as down the work string.

The equipment cage is designed and dimensioned to accommodate a range of ball valving components for actions like unlatching and relatching. You are free to repeat the process as much as necessary until the ball's cage is full. Also, it offers a delay or timing system that permits the debris to travel through the tool without being released.

The following characteristics are taken into consideration by the downhole equipment:

A downhole must be an extended tool with a connection to the work string visible at its higher end.

The mechanism's tool body is made up of a main body section that is tubular and includes upper and lower-end portions as well as a main body with a bore.

The long Equipment or tubular piston that fits into the main body's bore

a piston lock that secures the piston in the initial running position.

the valve seat-equipped piston

The downhole tool equipment is where the plastic ball valving part is kept. Production tools for oil drilling equipment can be removed from a tool assembly in the event that it gets trapped or fastened in the well bore by sand or debris. The enhanced releasing mechanism works by forcing a deformable ball valving component through the coil tubing bore until it is seated on the piston to run the pump.

Posted in Default Category on February 17 2023 at 02:28 PM

Comments (1)

No login
  • ahmedkhan