The Way To Remove The PS Correction Tape And The Correct Way To Use

How To Remove The PS Correction Tape From Paper?

The PS correction tape is mainly used to revise the wrong content when writing. The advantage is that it is more environmentally friendly than correction fluid, and it is easy to dry without a pungent smell. If you use correction tape and want to remove it, what should you do?

1. You can use frosted eraser sassafras gently wipe to prevent scratching the original text The original at the same time, but also remove the unwanted PS correction tape.

2. In the original place more than a few layers of PS correction tape, and then to the top of the hot Air, and finally scraped with a nail, you can all down.

3. You can try using a hair dryer to blow hot air on the back of the paper.

4. Scrape off with a triangular plate, but there are marks.

5. Apply sunscreen on the PS correction tape, a thick layer, and so five minutes to wipe off with a paper towel.

6. You can use a small and PS correction tape about the same size as the transparent tape, stick in that piece, press with the nail, slowly tear off, will S off a small layer of skin, but can not be seen if you have OCD can be used to stick a small piece of paper with a piece of transparent adhesive torn off, cut off the excess tape can be.

How To Remove The PS Correction Tape On The Table?

The PS correction tape on the table, you can first try to scrape with a fingernail or ruler, or use an eraser to wipe, with a wet rag can also be. If still useless, you can try to use some vinegar, and wipe with water, glue is generally alkaline and acetic acid can react. Or wipe with alcohol, wind spirit after wiping with a cloth can be removed.

The Correct Way To Use PS Correction Tape

1. Make sure that the surface to be modified is flat, while too smooth a surface is not easily covered by the PS correction tape.

2. Hold the correction tape head at a 45° angle against the part to be corrected and gently pull it straight to transfer the tape onto the paper.

3. In the position to end the correction, pause and lift vertically at an angle of 90 °, you can beautifully cut the PS correction tape.

4. If the inner tape is loose, please repeat the correction operation until the tape is rolled tightly.

 

Posted in Default Category on September 14 2022 at 07:06 AM

Comments (0)

No login