The daily maintenance of Fully Automatic CNC Machine is a very important link, which can not only affect the service life of the equipment but also prevent the failure during the work process from being delayed. In order to avoid equipment failures in daily work, the following small series describes what should be paid attention to in maintenance work:
1, choose the appropriate use environment, ensure the health of the equipment site to avoid dust entering the parts to affect the tightness of the workpiece. The use environment of the equipment will also affect the normal operation of the machine tool, so the installation of the machine tool should strictly comply with the installation conditions and requirements specified in the machine tool manual. If economic conditions permit, machine tools and ordinary machining equipment should be installed to facilitate repair and maintenance.
2, the daily maintenance of the machine tool should be equipped with CNC system programming, operation and maintenance of specialized personnel. These personnel should be familiar with the mechanical, numerical control system, strong electric equipment, hydraulic pressure, air pressure and other parts of the Machine tool and the use of the environment, processing conditions, and can be used correctly according to the requirements of Fully Automatic CNC Machine and system instruction manual.
3, clean in time. Such as air filter, electrical cabinet cleaning, printed circuit board cleaning. The inspection of the cable of the machine tool mainly checks whether the moving joints and corners of the cable have poor contact, broken line and short circuit faults.
4, the parameter memory of some CNC systems uses CMOS components, and the storage content is maintained by battery power supply when the power is off. When there is a low voltage alarm, the battery should be replaced in time, and the control system should be powered on, otherwise the storage parameters will be lost, resulting in the CNC system can not work.
5, long-term do not give the daily maintenance of the machine tool. When the equipment is idle, the CNC system should be often powered on and run empty when the Fully Automatic CNC Machine is locked.
In the Meiyu season when the air humidity is large, it should be powered on every day, and the electrical components themselves should heat away the moisture in the CNC cabinet to ensure the stable and reliable performance of electronic components.
Fully Automatic CNC Machine https://www.zjshuangzheng.com/Fully-Automatic-CNC-Machine-Category
Comments (0)