When used step-by-step, the Setup Linksys Extender technique makes it easy to set up the Linksys RE6500, a dual-band range extender intended for high-speed connectivity across wider spaces.
- First, unpack your RE6500 and set it up close to the main router. A stronger connection during configuration is ensured by keeping it close by during initial setup.
- Wait for the LED to become steady, signifying that the RE6500 is ready for installation, after connecting it to a power source.
- The RE6500 may be connected to your computer via an Ethernet connection or wirelessly using the default SSID that is accessible in the WiFi list on your device.
- Enter the IP address or the setup URL in any browser. Your extender will be identified by the installation wizard, which will then walk you through the next stages.
- Choose your home WiFi network when requested. Depending on your requirements, you can expand one or both of the 2.4GHz and 5GHz bands that the RE6500 supports.
- To enable the linksys RE6500 setup to sync with and enhance your current network, enter the router's WiFi password.
- To facilitate seamless traveling, you may now change the extended network name or leave it the same as your primary SSID.
- Allow the extender to restart after storing the settings. When the connection is successfully made, you will notice a solid LED.
- To ensure correct connectivity, disconnect your device and then rejoin the newly expanded network.
- Move the extender halfway between the router and the dead zone for optimal performance. The RE6500's integrated signal indications assist you in locating the perfect location.
Reset the RE6500 using its reset button and try again if the setup doesn't work or the device doesn't show up during configuration.
To know more go to our webpage.
Comments (0)